Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
The B wire is blue and is common.
The O wire is orange and energizes the 4 way (Reversing) valve for heat or a/c on a heat pump.
O- energized is cooling on Trane systems.
Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Thanks. I found indications of that elsewhere but I trust the answers I get here more than nearly everyplace else.
Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
07-08-2018, 05:43 PM
(This post was last modified: 07-08-2018, 05:49 PM by crokett™.)
I ran into an issue. My old tstat has connections for R, W2/X2,W1,Y,G,O,B
I had wires connected to each of those. I ran the system tests. Everything seems to work except Aux Heat. I connected the wire from W1 on old to W1 on the Nest, and the wire from W2/X2 to W2/Aux on the Nest. I might have a loose wire. I didn't check that yet, but the Nest detects the wires connected - it shows me a picture on the display of where they are connected. Is something on the heat pump overriding the heat strips? It's summer time after all.
Here is a picture of the Nest. This isn't mine. My connections are Y to Y1, G to G, O to OB, W1 to W1,W2/X2 to W2, B to C and R to RH:
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
07-08-2018, 06:04 PM
(This post was last modified: 07-08-2018, 06:05 PM by daddo.)
Be sure RH and RC are jumped.
Aux heat may be time delayed, it may run through an outdoor thermostat and the temp setting must be set 2* higher than the room temp.
On some thermostats, W1 is used for Gas/Fuel heating (Non- Heat pump).
Check the programing if there is one.
See if there is a "Sequence of operation" with the thermostat.
Frankly, I haven't dealt much with nest- too many complaints.
Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Nest instructions say no jumpers needed. R by itself can be connected to RH or RC. The Nest tells me that there may be a time delay - I waited several minutes. I'm wondering if it is running through an outdoor tstat. Temp setting was set to 75, which is room temp. this was a test using the Nest testing utility - it would call for heat no matter what the temp was. testing regular cooling and heating worked.
what do you mean by sequence of operations?
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
Sequence of operation means what the thermostat does at a particular setting.
Posts: 18,213
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
Worst case scenario can you temporarily replace the old thermostat and see if aux heat works?
Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
I figured it out. I spoke to Nest support and I had the aux wire in the wrong spot.