▼ 
10-29-2018, 09:34 PM
I cut some pressure treated lumber for a project and set it on the table saw for the weekend. BAD idea. Some WD 40 a Scotchbrite pad and about 1/2 hour of time and it is better. There is some staining.
I tried not believing. That did not work, so now I just believe
▼ 
10-29-2018, 11:10 PM
Yes. I did that once. Forgot that cutoff was there for a couple of days
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020  
Bill Wilson
This is Your Life...and we bet it will be a really good one because he works hard and really, really
10-30-2018, 06:55 AM
I was using my bandsaw to cut 45 degree angles on some short sections of 6x6, earlier this Summer. Put a couple of the off-cuts, end grain down, on my TS. I was horrified when I moved them a couple days later. Fortunately the rust cleaned up pretty easily, but lesson learned.
If you are going down a river at 2 mph and your canoe loses a wheel, how much pancake mix would you need to shingle your roof?
10-30-2018, 11:42 PM
Yup, don't leave lumber on cast iron surfaces. Sorry to hear.
10-31-2018, 12:17 PM
If you cut it on your TS, make sure to move your fence to get rid of the sawdust that got under it. It will really make a mess after a week or so. DAMHIKT.
▼
10-31-2018, 03:31 PM
(10-31-2018, 12:17 PM)sniper Wrote: If you cut it on your TS, make sure to move your fence to get rid of the sawdust that got under it. It will really make a mess after a week or so. DAMHIKT. I will remember that too. I was cutting on the RAS, and set it behind me on the TS.
I tried not believing. That did not work, so now I just believe
|
|
PSA
|
|
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
