Posts: 892
Threads: 0
Joined: Apr 2006
Location: Trout Creek, Montana
How about Fastcap Speed Brace 21X28. I know they are strong but not sure they are big enough, they would work for my compressor.
Treat others as you want to be treated.
“You only live once, but if you do it right, once is enough.” — Mae West.
24- year cancer survivor
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
Why not just use 2" angle iron? Use three- one on each side and one on the bottom. Or cut one side of the angle iron at 2" for the width and 6" for the sides and bend it into a U? Heat to anneal the bends.
You could also cut the pieces and have them welded. Ask a welding shop- they can make them while you watch I bet.
Posts: 7,421
Threads: 1
Joined: Sep 2005
In our shop we do all our welding in house. If you don't have that capability, any welding shop will be able to fabricate this for you. I think steel is a good choice for this application. The welding shop will know. And they should know if angle or tubing is required for the 600 pound weight. Also consider if you want them to add fudge lift moving capability. They will have to integrate that in the design.
No animals were injured or killed in the production of this post.
Posts: 438
Threads: 0
Joined: Sep 2007
08-29-2018, 10:38 AM
(This post was last modified: 08-29-2018, 10:38 AM by carwashguy.)
(08-29-2018, 10:23 AM)daddo Wrote: Ask a welding shop- they can make them while you watch I bet.
That was my solution too BUT the boss told me to find them online. I could have had them built and installed already but instead I have to waste an hour online and then involve everyone on this forum! What do I know....
Thanks for the recommendations
Posts: 31,093
Threads: 2
Joined: Mar 2003
Location: Athens, TN
Unistrut and all thread.
Rocket Science is more fun when you actually have rockets.
"The Constitution is not an instrument for the government to restrain the people, it is an instrument for the people to restrain the government." -- Patrick Henry
Posts: 1,612
Threads: 0
Joined: Oct 2008
08-29-2018, 11:52 AM
(This post was last modified: 08-29-2018, 11:55 AM by DieselDennis.)
Sounds like you opened your mouth for something that doesn't exist. And your boss doesn't want the liability of something you created (smart man).
I don't think you're going to find anything that's beefy enough to bolt through a concrete wall and support the weight at some distance and stand up to the vibration of an air compressor.
Looks like it's back to the fab shop. Have them do all the work (and take all the responsibility).
Posts: 64,651
Threads: 3
Joined: Feb 2007
Location: Merryland
Cold you use a free standing shelving "H" frame shelf and fasten it and the compressor to the wall?
Like this?
