Posts: 1,998
Threads: 1
Joined: Aug 2016
(12-30-2019, 03:58 PM)varkpilot Wrote: electric dryer heating coil - is it either ALL on or ALL off? clothes dry but not as fast as usual.
First I would check that the exhaust vent is not clogged. Try Google your dryer model and look up a electrical schematic and it will show if there is just one element or several elements. Roly
Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
Just went through this. Check for lint anywhere along the exhaust path.
Carolyn
Trip Blog for Twelve Countries: [url=http://www.woodworkingtraveler.wordpress.com[/url]
"It's good to know, but it's better to understand." Auze Jackson
Posts: 4,867
Threads: 0
Joined: Jul 2003
Location: McKinney, Texas
another vote for exhaust. Ours stopped drying thoroughly, subsequently discovered my wife had a christmas decoration partially blocking the vent outside. Cleared it and went back to working normally.
"Oh. Um, l-- look, i-- i-- if we built this large wooden badger" ~ Sir Bedevere
Posts: 16,604
Threads: 0
Joined: Oct 2002
Location: Ra-cha-cha, NY
12-30-2019, 05:24 PM
(This post was last modified: 12-30-2019, 05:27 PM by TDKPE.)
(12-30-2019, 03:58 PM)varkpilot Wrote: electric dryer heating coil - is it either ALL on or ALL off? clothes dry but not as fast as usual.
There are some that have three leads to three elements, so it's possible that one or more are burned out. But most have only a single element and just cycle the element to control the heat.
Not hard to check, though.
Got a make and model?
Tom
“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Posts: 6,128
Threads: 0
Joined: Aug 2005
Location: Madison, WI
I had the same issue and there were two heating coils. Only one went bad.
Pedro
I miss nested quotes..........
Posts: 64,663
Threads: 3
Joined: Feb 2007
Location: Merryland
Too many bends in the discharge hose?
Too long?
Full of lint?
Kinked?
Have you looked inside the vent outside the house?
Posts: 36,539
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Does it squeak when it runs? My previous one did. Bad belt around the drum so the clothes weren't tumbling as they should. After I replaced the belt the dryer ran a lot better.
Posts: 24,331
Threads: 0
Joined: Feb 2002
Location: Elizabethtown, KY
Had a dryer quit drying completely.
Turned lights in room off, opened dryer door and pushed button so it could run.
Saw one element glow, other didn't.
took about an hour to replace both (just to make sure),
Recently had ours slow down. checked exhaust and found crud build-up on inside of louvers. Pulled off and it was back to full heat.
"Truth is a highway leading to freedom" --Kris Kristofferson
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I kept losing heating coils and it turned out to be related to the kink in the vent on the way through the outside wall. I re-did it and managed to get it almost straight. I would be surprised if too many of them have multiple heating elements, they are built as cheaply as possible.
