Woodnet Forums › › Active › Woodworking Power Tools v
Posted in wrong forum

▼
cputnam Offline
multi-slacker
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
#7
02-19-2020, 10:58 PM (This post was last modified: 02-20-2020, 01:08 AM by cputnam.)
For table or bench legs, why do we cut 4 shoulders?  Are the two shorter ones all that useful?
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Find
Reply
▼
iclark Offline
Moderator
Posts: 14,849
Threads: 10
Joined: Jan 2010
Location: southeastern VA
#8
02-20-2020, 12:33 AM
(02-19-2020, 10:58 PM)cputnam Wrote: For table or bench legs, why do we cut 4 shoulders?  Are the two shorter ones all that useful?

Which are the "two shorter ones"?

I have certainly seen legs with only 2 shoulder at the top when there would not be anything sitting on where the other 2 shoulders would be.
"the most important safety feature on any tool is the one between your ears." - Ken Vick

A wish for you all:  May you keep buying green bananas.
Find
Reply
cputnam Offline
multi-slacker
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
#9
02-20-2020, 01:06 AM
Thanks for responding. I screwed up and posted in the wrong forum. I'll repost
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Find
Reply
Thread Modes
Posted in wrong forum


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.