Posts: 12,197
Threads: 2
Joined: Nov 1999
Location: Nebraska City
I used half height slots (not sure what to call that!) to make a grid out of 1/4" MDF for a silverware drawer. There's enough 'flex' in the MDF that you can cut the pieces to width for a very tight fit against the drawer sides so it stays put.
Posts: 227
Threads: 0
Joined: Jan 2005
I used 1/4 inch maple with the top rounded with a router. I then placed a 1/4 dado blade in the saw and took the drawer with the utensils to my shop and cut the maple to length, then made half lap joints based on the size of the utensils.
Posts: 8,488
Threads: 1
Joined: Mar 2000
I began an often-promised but long procrastinated shop reorg project a couple weeks ago. As part of that effort, I'm putting dividers in drawers.
Like the others, I made them by using half-height slots. I'm using up scraps of 1/4" ply of any quality. Drawers in the shop are of only a few sizes, but they all have the same width and depth, so gang-cutting the dividers is easy.
My first drawer dividers took 15 minutes to make. It's not "pretty", but it is functional, and this is shop furniture we're talking about. You can spend however much time you desire making the joints tight. Pic:
[attachment=24131]
Posts: 21,964
Threads: 0
Joined: Oct 2003
That looks just right.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Posts: 675
Threads: 0
Joined: Aug 2011
I had a bunch of reclaimed (auction off-lot) 3/8" plywood that I made some chisel drawers for. Simple, functional joinery -- just glued and clamped various pieces together. (two up on the ends and sides to form faux "dado" or "rabbet" joints)
