Jet Mini Lathe 1"x42" Belt Sander

[Sullivan]

Just finishing up this 1"x42" belt sander attachment for my Jet mini lathe.  I still need to add the table - for now it will just be 90 degrees, I will make it adjustable later.

Over the years I have been tempted to purchase a small belt sander for various projects but really didn't have the shop space.  Since I only turn occasionally I decided to make a lathe powered belt sander.  The nice thing was that I already had all of the parts except for the lathe faceplate ($20), bolts and top knobs.  The knobs are for tensioning and tracking adjustment.  I had a little trouble with belt tracking but got that sorted out by crowning the top skateboard wheel (originally I had only crowned the plywood drive wheel).

[stav]

That is an inventive looking setup. Was that your own plan?

[Sullivan]

That is an inventive looking setup. Was that your own plan?

Yes, my design.  I looked at several online for ideas.  Here is the Sketchup model and what it will ultimately look like:

[R Clark]

That is too cool!  


Like you, I want a small belt sander; I have a Jet Mini.  This might be a project for next winter.

How did you crown the skateboard wheel?

[Sullivan]

That is too cool!  


Like you, I want a small belt sander; I have a Jet Mini.  This might be a project for next winter.

How did you crown the skateboard wheel?

Using a hole saw I made a couple of plywood discs larger than the skateboard bearing but smaller than the wheel.  I then used these to clamp the wheel to a bolt that fit the bearing (note skateboard bearing has 8mm ID, 5/16" bolt is same diameter as 8mm bolt).  Chucked the bolt into my drill press and went at it with a sanding block.  It doesn't take much crown.

[FireWood]

Using a hole saw I made a couple of plywood discs larger than the skateboard bearing but smaller than the wheel.  I then used these to clamp the wheel to a bolt that fit the bearing (note skateboard bearing has 8mm ID, 5/16" bolt is same diameter as 8mm bolt).  Chucked the bolt into my drill press and went at it with a sanding block.  It doesn't take much crown.

you have a mini lathe, yet you used a drill press to put a crown on a wheel?  
 

[Sullivan]

you have a mini lathe, yet you used a drill press to put a crown on a wheel?  
 

Since the skateboard wheel has a hole though the middle with bearings there is no way to use the lathe centers.

[R Clark]

Thanks!  I don't have any skateboard wheels hanging around, but Amazon is ready when I am...

[Sullivan]

Got the table and dust collection fitting installed today.  Went ahead and spent the time to make the table adjustable (was originally going to do only 90 degrees, adjustable later).  Only thing left is the platen behind the belt and a knob for the table adjustment.

[Scrambler48]

Just finishing up this 1"x42" belt sander attachment for my Jet mini lathe.  I still need to add the table - for now it will just be 90 degrees, I will make it adjustable later.

Over the years I have been tempted to purchase a small belt sander for various projects but really didn't have the shop space.  Since I only turn occasionally I decided to make a lathe powered belt sander.  The nice thing was that I already had all of the parts except for the lathe faceplate ($20), bolts and top knobs.  The knobs are for tensioning and tracking adjustment.  I had a little trouble with belt tracking but got that sorted out by crowning the top skateboard wheel (originally I had only crowned the plywood drive wheel).

Neat idea!