Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
I've seen the sidebyside saws bolted together, even different brands bolted together.
Guess I've never cared for the concept.
Back when I did have 2 saws, I kept a dado on the lesser saw. My main saw did all the ripping and cross cutting, which it still does.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 12,597
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
Geez, a PM 66 and a Unisaw in the same shop? Excuse me if I don't feel sorry for you!
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 7,008
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
How would I set up two tablesaws in my shop?
One on the top of the other.
Regards from Perth
Derek
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
Fred,
My 66 was free years back and the Uni was $290. Can you blame me?
Semper fi,
Brad
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
But seriously, the only reason I bought a second saw was because switching between blades is becoming detrimental to my process now that I'm building for money. If it weren't for that I wouldn't even have considered a second saw.
Semper fi,
Brad
Posts: 2,201
Threads: 0
Joined: Dec 2006
Set up the crosscut saw as your out feed table for the ripping saw?
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
I'm thinking that but I think the Uni is about 1/4" taller than the 66. Once I clean the machine oil out of the mating surfaces (seller put it there to protect against rust) I'll get a good measure.
Semper fi,
Brad
Posts: 3,657
Threads: 0
Joined: Jan 2005
Typical setups I've seen are side to side or back to back though nothing says you have to attach the two together.
