Posts: 12,871
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(01-04-2021, 01:52 PM)cputnam Wrote: I have a Steuben Glass sculpture (Goose in Flight) which was a gift to my father on his retirement for which the right wing has broken off where it meets the body.
What is the best adjesive for glass?
I believe a repair has been attempted and failed. What is the best thing(s) to do to the surface prior to reattaching the wing?
Thank you for your help
Stueben Glass is such high end work that it's worth doing right. I would contact Stueben to get their input. Maybe they do repairs. If not, I'm sure they know the best way to go about it. Good luck.
John
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
(01-04-2021, 04:10 PM)jteneyck Wrote: Stueben Glass is such high end work that it's worth doing right. I would contact Stueben to get their input. Maybe they do repairs. If not, I'm sure they know the best way to go about it. Good luck.
John
(01-04-2021, 10:30 PM)JTTHECLOCKMAN Wrote: I second this 100%
Thanks John (plural). They have been emailed - awaiting a reply.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
Steuben does not repair but referred me to an ex-employee who they said was an artist at repair. This gent uses UV curing adhesive. Since shipping, insurance, and his charge would closely approach the value of the piece, I'm off to research UV curing adhesives,
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 1,531
Threads: 0
Joined: Jan 2007
I know this got kicked around the pen turning forum I belong to IAP penturners. We use CA as a finish on pens and are always looking for other strong finishes and this type of finish or adhesive was played around with. One thing that stood out was the light source had to be strong and not all uv lights work well. They are basically flashlights. I use to go to woodworking shows and there was a guy there that always demonstrated this adhesive but can not remember the name. If you look for the traveling woodworking show maybe you can find out who the vendor was.
John T.
Posts: 36,538
Threads: 3
Joined: Nov 2004
Location: RTP, NC
You will likely need to clean any old adhesive off the repair area before trying the UV one. If you know what kind of adhesive was removed, look into whatever solvent is best for that adhesive. If you don't know, I would use either DNA or acetone. I've not seen an adhesive either of those can't remove. They won't hurt the glass.
Posts: 1,531
Threads: 0
Joined: Jan 2007
