Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
I had a reliant 3hp, kept as a second backup shaper. Sold it a few years ago.
I would imagine the nuts are the same as my powermatic, and a lot of others.
Ck with Grizzly. They will have nuts, and also the complete shaft....unless there is a China/Taiwan shipping problem.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 12,888
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
Have you checked McMaster Carr? If the rotation is reversible a LH thread would make no sense. My old Grizzly used two jamb nuts on top. Never had an issue.
John
Posts: 16,471
Threads: 0
Joined: Mar 2005
01-13-2021, 10:11 PM
(This post was last modified: 01-13-2021, 10:19 PM by Bill_de.)
(01-13-2021, 11:20 AM)Cdshakes Wrote: My sister is an admin-- her boss does woodworking on the side and bought some used Reliant DD32 shaper. Doing some research, seems Reliant was the house brand for the now defunct Woodworkers Warehouse retail chain (i remember this company well)
Her boss tasked her with finding 2 missing nuts (heheheh) for the 1/2" bore shaft. Looking at some vids online and such, it seems the top one was reverse thread.
Not sure if it would just be easier to buy the whole 1/2" shaft with nuts on it already? If so, what would work with this tool?
I'm finding more info online about a newer model i guess (DD34)... her boss has the DD32.
Colin
My favorite place for hardware
Hex nuts, Stainless steel 18-8 - Left hand (reverse) thread - Bolt Depot
Or
https://www.mcmaster.com/left-hand-threaded-hex-nuts
--
See ya later,
Bill
Posts: 16,604
Threads: 0
Joined: Oct 2002
Location: Ra-cha-cha, NY
(01-13-2021, 11:20 AM)Cdshakes Wrote: Looking at some vids online and such, it seems the top one was reverse thread.
I can't get past this - if it has two nuts, they would both have the same thread. And if the shaper is reversible, why would they bother with a LH thread, as asked earlier?
Tom
“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Posts: 2
Threads: 0
Joined: Feb 2020
The left hand top double nut is a std import shaper configuration. Grizzly should have the part
Posts: 2
Threads: 0
Joined: Feb 2020
Well the left hand top thread thats a smaller diameter than the primary right hand thread is limited to that specific general model (regardless of the brand sticker slapped on the front)
Double nuts on a common thread are more common but still not common outside of the little delta hd/pm 25-27 or some of the old American vintage shapers.
A single nut (or bolt in felders case) and a pinned or tabbed washer is the more common reversible spindle retention method currently.
