Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
Battens on the underside?
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 18,550
Threads: 0
Joined: Jul 2008
Location: Free At Last!
"Battens on the underside?"
I think they would have to be too thick to do any good. But maybe that combined with narrow alternating grain orientation boards?
Posts: 14,856
Threads: 10
Joined: Jan 2010
Location: southeastern VA
Can you use quarter-sawn white oak?
"the most important safety feature on any tool is the one between your ears." - Ken Vick
A wish for you all: May you keep buying green bananas.
Posts: 18,550
Threads: 0
Joined: Jul 2008
Location: Free At Last!
"Can you use quarter-sawn white oak?"
I could use QSRO, but not for what I'm charging. If I was going to finish it to leave a wood finish, I would.
Posts: 8,408
Threads: 1
Joined: Mar 2000
02-04-2021, 06:57 AM
(This post was last modified: 02-04-2021, 06:58 AM by R Clark.)
Dimensions?
Based on your description, it's not going to be attached to the table. It's going to be painted, so why oak? is that just what you have on hand?
I was thinking about mitered sections, but eight sections, not four. But that's a lot of fussy work, for that piece.
Another thought: since it's going to be painted, you could have more than just a couple of boards glued together. I would think think that more strips of narrower width would give you some protection against cupping, particularly if you avoid pieces that are too far off the quartersawn orientation.
Posts: 2,393
Threads: 0
Joined: Jul 2005
... if you are going to paint it .... just use banded plywood ....
Posts: 13,485
Threads: 0
Joined: Oct 1999
If you are going to paint it, Oak is the harder choice. The grain is so open you’ll need to use a filler to get any sort of smooth finish.
