Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
All of the firebacks I have seen were cast iron, and thicker than 3/4". I don't know if that would make a difference in effectiveness
Posts: 64,335
Threads: 3
Joined: Feb 2007
Location: Merryland
(02-19-2021, 06:32 PM)TyG Wrote: I have a large bricked-in, traditional fireplace. Concrete floor. I've been researching firebacks to help with the heat efficiency. Now, would it also help to have a steel floor? Would it be a benefit if I made a floor and fireback out of 3/4" steel.
Even with that, you'll still loose most of your heat out the flue.
Are you just trying to get more heat from it or use it to heat your house/room? It's hard to do without some sort of forced air/hear exchange system and a good set of doors. Fireplaces are pretty inefficient because most of the heat goes out the flue. Ideally, a wood stove insert will allow you to retain heat and control of the intake and exhaust so a lot less wood and a lot more BTUs.
Posts: 36,498
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Our last house had a fireback. I took it out and put in a wood stove insert. The insert made a huge difference - it would sweat me out of the room even with a small fire in it.
Posts: 159
Threads: 0
Joined: Jan 2010
Traditional fireplaces had their use before central heating. Now they are for ambiance. Burning material consumes a lot of air and must create a draft up the chimney. It must pull air out of the room and that means outside air must enter the house. Unless your fireplace was installed with an exterior makeup air source, you will send warm room air up the chimney and pull in cold air. In the end, your furnace will run a lot.