07-07-2021, 04:42 PM
At the cabin I started redoing the outside shower. The old pipe was rusted through. I will have to run one and one half inch pvc 22.5 ft and will only have one half inch of drop. Has to run from back side to halfway up the North side some what kitty corner to get to the nearest drain under the sink in the bath. I used my old water level to get the measurement. Should I raise the shower for more fall in the pipe? Can't gain a whole lot but some.
Secondly is using metal strapping to the joist to hold it in place ok or use blocking.
I'm also thinking about getting a small 110 v water heater to put on the backside for quicker hot water. Otherwise it has to come from even farther than the drain. Don't have 220 on that side for an on demand heater and not sure breaker has room so a small heater will have to work. Any recommendation. Thanks.
Secondly is using metal strapping to the joist to hold it in place ok or use blocking.
I'm also thinking about getting a small 110 v water heater to put on the backside for quicker hot water. Otherwise it has to come from even farther than the drain. Don't have 220 on that side for an on demand heater and not sure breaker has room so a small heater will have to work. Any recommendation. Thanks.