Woodnet Forums › › Active › Woodworking Power Tools v
Craftsman Laser Trac Digital Level Parts

▼
museumguy Offline
Member
Posts: 2,078
Threads: 1
Joined: Feb 2009
Location: Mechanicsville, Md
#10
10-10-2021, 08:42 AM
I have a Craftsman Laser Trac digital level, 320.48293 and the battery door broke. I'm usually pretty good at finding parts however this time I'm coming up empty. Any body have any ideas?
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Find
Reply
▼
kurt18947 Offline
Member
Posts: 1,687
Threads: 0
Joined: Apr 2005
#11
10-10-2021, 06:54 PM
(10-10-2021, 08:42 AM)museumguy Wrote: I have a Craftsman Laser Trac digital level, 320.48293 and the battery door broke. I'm usually pretty good at finding parts however this time I'm coming up empty. Any body have any ideas?
Any luck finding the OEM? The list at vintagemachinery says 320.xxxx is Chervon (Asian). That might be tough.
Find
Reply
museumguy Offline
Member
Posts: 2,078
Threads: 1
Joined: Feb 2009
Location: Mechanicsville, Md
#12
10-12-2021, 06:33 PM
No luck. I have a feeling I'm just going to tape the door shut when I use the level.

Thanks for the info.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Find
Reply
Cabinet Monkey Offline
Member
Posts: 770
Threads: 0
Joined: Jan 2007
Location: ATL
#13
10-16-2021, 11:29 AM
I believe that was also marketed under the Husky brand.  So, you might try searching their part network.
Find
Reply
▼
Handplanesandmore Offline
Member
Posts: 2,382
Threads: 0
Joined: Dec 2011
#14
10-16-2021, 11:48 AM
Since the door or cap is on the end of the level, I'd try holding the cap in place with a large binder clip, and then remove the handle.

Simon
Find
Reply
museumguy Offline
Member
Posts: 2,078
Threads: 1
Joined: Feb 2009
Location: Mechanicsville, Md
#15
10-16-2021, 02:57 PM
(10-16-2021, 11:48 AM)Handplanesandmore Wrote: Since the door or cap is on the end of the level, I'd try holding the cap in place with a large binder clip, and then remove the handle.

Simon

Hmmm, we may have a winner. Thanks.

Also, I'm going to research the Husky suggestion. Thanks also.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Find
Reply
Thread Modes
Craftsman Laser Trac Digital Level Parts


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.