02-27-2022, 04:42 PM
Here it is. (It was a bit of a rush job as I need to be in Philly on Wed so I'll swing down to DC on Wed evening. I didn't "do the math" on when I needed to be in Philly for work so that made me work faster than I normally do. I just put the last coat of finish on it this AM).
It is solid cherry and all the supports are dovetailed into the horizontal boards. I didn't want any mechanical fasteners, but a few of the DTs were a little loose so I drove a screw up through the underside into the center of the vertical support, to allow for expansion/contraction. Unless you lie on the floor, you won't see the screws.
It measures approx 5 ft long by 38" (ish) high. The finish is Watco's Danish Oil (Natural) followed by 3 coats of oil-based semi-gloss poly.
It is solid cherry and all the supports are dovetailed into the horizontal boards. I didn't want any mechanical fasteners, but a few of the DTs were a little loose so I drove a screw up through the underside into the center of the vertical support, to allow for expansion/contraction. Unless you lie on the floor, you won't see the screws.
It measures approx 5 ft long by 38" (ish) high. The finish is Watco's Danish Oil (Natural) followed by 3 coats of oil-based semi-gloss poly.
Dumber than I appear