Posts: 38,525
Threads: 0
Joined: Feb 2002
Location: East Texas
I still have my DJ20 original cutter head in a box. Been there for 10+ years. Prolly gonna get tossed soon.
Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick
Mark
Posts: 6,179
Threads: 0
Joined: Dec 2002
Location: Bothell, WA
Transfer stations around here have a separate area for metal recycling.
Cellulose runs through my veins!
Posts: 12,606
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
Over the years I've seen a few guys sell theirs to someone who was rebuilding an older machine and needed to have a new cutterhead machined...but generally speaking there's little market for them. I tossed my planer head and gave away the knife sets here. I still have the jointer head, I used it in my hydraulic press to bend curves into sheet metal (once). Otherwise it's just sitting here gathering rust, I gave those knife sets away as well. Once in a while someone needs a gib or screws from one, and you could sell the knives.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 13,412
Threads: 4
Joined: Jun 2007
Location: New Jersey
Not to be contrary, but I never "got" the concept of a helical head for a Jointer. Planer, yeah, I get it, but when you face joint, you end up putting it through a planer, so nothing gained from the helical. Perhaps it has value for edge jointing, but for me I always hit edges with a #7 before panel glue ups. I'm also ok with knives on a planer, as I always use a smoothing plane on those surfaces as well. I guess its just me.
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Posts: 16,609
Threads: 2
Joined: Oct 1999
10-04-2022, 08:47 PM
(This post was last modified: 10-04-2022, 10:55 PM by Tapper.)
The obvious advantage is not having to sharpen and set knives on a jointer, not to mention being able to rotate inserts - 4 cutting sides. Carbide stays sharper much longer than HSS. Had them on my 8" jointer and 15" planer for years. Would never go back.
Doug
"A vote is not a valentine. You aren't professing your love for the candidate. It's a chess move for the world you want to live in."
Posts: 10,777
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
10-04-2022, 09:25 PM
(This post was last modified: 10-04-2022, 09:33 PM by EdL.)
What Doug said.
Sharpening went from a really good retired fellow that didn't charge much and 4 miles away to a 20 mile trip to a business. They do good work, they have overhead like any other business and the price shows it.
Still, I take my sawblades there.
Ed
Posts: 3,535
Threads: 0
Joined: May 2005
Location: Greater Fort Collins Area, CO
db Admiral is another one. There is often 9-12db difference between them at minimum. This on top of the near zero tear-out are the key values for me. I have a helical head on my new j/p coming at the end of November, wouldn’t have gone any other way having had straight knives and had enough ‘fun’ with the setting of them to last a life time.
Michael
Every day find time to appreciate life. It is far too short and 'things' happen. RIP Willem
