Posts: 313
Threads: 5
Joined: Jul 2016
My guess would be glue up and turn thick, then carve - agree with your first thought. Not too hard to power carve while mounted on the lathe.
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
Could have used one of those power carvers with the course grit on a four inch grinder and then sanded of which I have seen
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 27,952
Threads: 0
Joined: Jul 2002
Location: Pacific ocean now much further away!
Posts: 1,742
Threads: 13
Joined: Jul 2001
Another approach is a ring stacking technique: take a flat board (here, a glue up of small pieces), then saw a series of successively smaller rings out of the board. Stack, glue and finish sand.
-Mark
If I had a signature, this wouldn't be it.
Posts: 4,787
Threads: 0
Joined: Jan 2005
Mystery Solved!
I was able to find an email address for the artist of this piece, Richard Morris. I reached out to him and asked how it was made. Here is his reply:
" It is a segmented bowl with a 2” thick wall at the top going to about 1” towards the bottom. I use a 2” carbide bit on an air grinder. I use the 24 spots to lock the bowl in the lathe. The grinder is in a wooden sled and a wooden table on in place of the tool rest. I put 12 scallops inside and outside. "
Posts: 1,531
Threads: 0
Joined: Jan 2007
My guess scrollsaw. I have done baskets like that and just stack rings.
John T.
