Posts: 2,385
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
Joint one edge, then use sled or miter gauge.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Posts: 22,325
Threads: 0
Joined: Dec 2005
Location: Oakdale, MN
06-16-2023, 09:14 AM
(This post was last modified: 06-16-2023, 09:15 AM by packerguy®.)
Mill the length square, then score a line on all 4 faces, and bandsaw it. Unless you are terrible at bandsawing (which if youre making bandsaw legs, you must not be) it will be fine.
Or if you have hand sawing skill, just crosscut it off by hand.
What am I missing?
Once Favre hangs it up though, it years of cellar dwelling for the Pack. (Geoff 12-18-07)
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
I do have a bandsaw. But I didn't even think to consider it. It's a Delta 14". Can it cut a good, square end on a blank? I've never tried it.
I thought about rolling the blank 90* after each pass across the table saw, lining up the kerf on the blade but wanted other thoughts first.
Semper fi,
Brad
Posts: 14,850
Threads: 10
Joined: Jan 2010
Location: southeastern VA
06-16-2023, 10:04 PM
(This post was last modified: 06-16-2023, 10:04 PM by iclark.)
I have no idea what "band saw turned legs" are.
My first thought is that you are making legs that are larger in diameter at points along the height of the leg than they are at the top (where you want them square).
If that is the case, then a rip hand saw might be your best bet.
If you do it on a BS, the best solution that I have seen is to use one or more hand screw clamps (tips rubbing on the BS table) to stabilize the blank and make sure that it does not catch and spin.
"the most important safety feature on any tool is the one between your ears." - Ken Vick
A wish for you all: May you keep buying green bananas.
Posts: 10,773
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
Put it on the DeWalt 16" ras and cut it...
Ed
