12-29-2023, 12:14 PM
So, if my door opening is 24” x 22”, I guess I di t want my door to be that exact size? Do I take 1/16” off each side? More? What factors matter?
▼ ▼ 
01-02-2024, 07:32 PM
(This post was last modified: 01-02-2024, 09:34 PM by firefighter.)
Build it to that size and hand plane it down it fit with even gap all around.
Roger
Life isn't like a box of chocolates. It's more like a jar of Jalapenos. What you do today, might burn your rear tomorrow. 9-11 Never forget  (12-29-2023, 12:14 PM)David Stone Wrote: So, if my door opening is 24” x 22”, I guess I di t want my door to be that exact size? Do I take 1/16” off each side? More? What factors matter? Inset doors? Yes.
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020 ▼
01-03-2024, 07:24 PM
(01-02-2024, 10:06 PM)Stwood_ Wrote: Inset doors? Yes. We always allowed 1/8" reveal all around so 1/4" smaller than opening. Obviously, it is up to the OP as to how large/small of a gap. This is for an inset door.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.
Garry
01-04-2024, 11:14 AM
(01-02-2024, 10:06 PM)Stwood_ Wrote: Inset doors? Yes. I have a 2016 catalog from woodworkershardware.com Data should still be good. The "155" is shown with overlay doors only. People there are great to worked with, when I called with lots of questions, returns, instructions etc.. Phone is 800-383-0130 Norm |
|
Door Size for Blum 155 No Protrusion?
|
|
|
|
|
Users browsing this thread: 1 Guest(s)