Woodnet Forums › › Active › Tool Swap N' Sell v
WTB: Spindle for pre 1957 Buffalo Forge Drill Press

▼
Rick_B Offline
Member
Posts: 4,155
Threads: 2
Joined: Feb 2003
Location: Winston Salem, NC
#4
01-05-2024, 06:12 AM (This post was last modified: 01-06-2024, 05:59 AM by Rick_B.)
[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Looking for a good spindle with chuck release nut for a pre 1937 Buffalo Forge 15" drill press.  If you have something let's talk[/font]

[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Rick[/font]
Rick

Find
Reply
▼
Rick_B Offline
Member
Posts: 4,155
Threads: 2
Joined: Feb 2003
Location: Winston Salem, NC
#5
01-05-2024, 11:55 AM
(01-05-2024, 06:12 AM)Rick_B Wrote: [font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Looking for a good spindle with chuck release nut for a pre 1937 Buffalo Forge 15" drill press.  If you have something let's talk[/font]

[font=Arial, BlinkMacSystemFont, -apple-system, "Segoe UI", Roboto, Helvetica, sans-serif]Rick[/font]

So a few specifics - doesn't have to be a Buffalo spindle.  It does need to be a6 spline, 5/8" diameter, at least 15" long with a spline length of at lease 6-1/2" and a taper chuck fitting.

Rick
Rick

Find
Reply
Thread Modes
WTB: Spindle for pre 1957 Buffalo Forge Drill Press


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.