Over the years my collection of caving tools has grown. Now that I have too many in-tool roles I need to come up with a better system. My thoughts are something like two haves hinged like a book (so I can stand them up) with tools on each side. This way I can put the back in draws when not in use. Any other ideas? I may also decide to do this with chisels.
Captain Kirk was talking about my shop when he said: Space the final frontier!
[attachment=49645 Wrote:TheCabinetmaker pid='8169897' dateline='1706492993']Over the years my collection of caving tools has grown. Now that I have too many in-tool roles I need to come up with a better system. My thoughts are something like two haves hinged like a book (so I can stand them up) with tools on each side. This way I can put the back in draws when not in use. Any other ideas? I may also decide to do this with chisels.
This what I use, it's not what you have in mind but might start the creative juices. It's a take-off of one Dave Stetson used in his studio. I made a few changes, and I can roll it into a corner when not in use. No, I haven't had problems with the magnets and sharpening.
Tool chest?
[attachment=49648]
Too small?
[attachment=49649]
Not sure IF I can lift this one...
[attachment=49650]
Top Til is a bit full..
[attachment=49651]
Lumber was Ash..
[attachment=49652]
One of the drawers is for chisels...
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
