DRILL PRESS IS SOLD
Up for sale is a recently completed Delta DP-220 14” bench top drill press. Serial number is 55-4813 which dates it as 1947. It is a DP-220 head with high speed pulleys on both the motor and spindle. Measured speeds are 4980, 2444, 1258 and 650. Motor pulley has small chip in top step – does not interfere with function. Entire machine was disassembled, cleaned and painted.
The machine has new spindle bearings – I used standard 6202 5/8 bore bearings. Spindle nose run out is less than .001”.
The motor is a Delta 1/3 HP capacitor start single phase currently wired for 110. Motor was completely disassembled, cleaned and painted. Reassembled with new bearings. It has the Delta switch on the junction box with the on/off switch rod.
It has a new belt, tilt table (some arc of shame) depth stop and a new (used) return spring.
Based on what I have into this drill press, I am looking to get $250 for it but will certainly entertain any reasonable offers. Local pick up is preferred but I can assist with delivery within a reasonable distance of Winston Salem, NC for a small fee. I can also hold until arrangements can be made (indefinitely) with payment.
Thanks for looking
Rick
[attachment=50371]
[attachment=50372]
[attachment=50373]
[attachment=50374]
[attachment=50375]
[attachment=50376]
Up for sale is a recently completed Delta DP-220 14” bench top drill press. Serial number is 55-4813 which dates it as 1947. It is a DP-220 head with high speed pulleys on both the motor and spindle. Measured speeds are 4980, 2444, 1258 and 650. Motor pulley has small chip in top step – does not interfere with function. Entire machine was disassembled, cleaned and painted.
The machine has new spindle bearings – I used standard 6202 5/8 bore bearings. Spindle nose run out is less than .001”.
The motor is a Delta 1/3 HP capacitor start single phase currently wired for 110. Motor was completely disassembled, cleaned and painted. Reassembled with new bearings. It has the Delta switch on the junction box with the on/off switch rod.
It has a new belt, tilt table (some arc of shame) depth stop and a new (used) return spring.
Based on what I have into this drill press, I am looking to get $250 for it but will certainly entertain any reasonable offers. Local pick up is preferred but I can assist with delivery within a reasonable distance of Winston Salem, NC for a small fee. I can also hold until arrangements can be made (indefinitely) with payment.
Thanks for looking
Rick
[attachment=50371]
[attachment=50372]
[attachment=50373]
[attachment=50374]
[attachment=50375]
[attachment=50376]
Rick