Posts: 1,617
Threads: 0
Joined: Feb 2010
Location: Coast of Maine
Pi X Diameter = Circumference
3.14 x 3 7/16" (3.437") = 10.8"
Gary
I've only had one...in dog beers.
"You can see the stars and still not see the light"
The Eagles: Already Gone
Posts: 839
Threads: 0
Joined: Jun 2007
thank you. Makes it easier for me to figure out the flute spacing and the jig to do it.. Even gave thought to beading and also both beads and flutes.
Posts: 14,849
Threads: 10
Joined: Jan 2010
Location: southeastern VA
If this is dry, it is amazing that it does not have multiple cracks.
If it is green, then the sooner you turn it and split it in half, the better. Once turned and split, you can expect the cut side to go convex as it dries.
Progress pics and final pics (with or without progress pics) are always welcome.
"the most important safety feature on any tool is the one between your ears." - Ken Vick
A wish for you all: May you keep buying green bananas.
Posts: 839
Threads: 0
Joined: Jun 2007
Again thanks. It was more than dry. It has been in my shed for 10 plus years. I had sealed the ends and I cut 3inches off each end before I started. I made a jig and ended up beading it rather than flutes. with the circumference known it was easy to get the beads made right. Hurt my arm doing it though, patting myself on the back. I sanded it then halved it. It is already mounted. Looks good. All I have left is to make the doors. More sanding the whole thing and finish. Get it out my little shop and move on. Did I mention more sanding, I'm sick of sanding.
Sorry I don't post pics. tried in the past and my slower than slow internet makes it a chore.