Woodnet Forums › › Active › Woodworking Power Tools v
Jet DC Remote

▼
Bill Holt Offline
Member
Posts: 2,388
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
#5
06-06-2024, 08:18 AM
My Jet DC is likely 15 yrs old.  The remote will not turn the DC off.  I tried to open the remote to check/clean the contacts, but stopped just short of breaking the back.  Anyone got a suggestion?
"I tried being reasonable..........I didn't like it." Clint Eastwood
Find
Reply
▼
fredhargis Offline
Member
Posts: 12,608
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
#6
06-07-2024, 02:57 PM (This post was last modified: 06-07-2024, 02:58 PM by fredhargis.)
I've had a few of them fail over the years and I was never able to revive one. If you can't get a replacement from Jet (I'll bet you can't, or the remote will cost 1/2 what a new DC would cost) I would try to replace the whole thing with an aftermarket (or shop built) unit. My current setup is a home built set up using a contactor that switches on/off with a cheap light switch ($10 each around Christmas time) remote. I keep a few spares so that when it fails i simply swap it out.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Find
Reply
Bill Holt Offline
Member
Posts: 2,388
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
#7
06-08-2024, 07:41 AM
Thank you, Fred.

Guess that's what I expected.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Find
Reply
Thread Modes
Jet DC Remote


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.