10-27-2015, 10:53 PM
Last year I picked up a used PM2000. Looked great and the motor ran great. Most of the time it still does. But occasionally, maybe 10-15% of the time the motor just shuts off a few seconds after it turns on and won't turn on again. You have to wait a couple of minutes and sometimes unplug it. Again it doesn't happen often but it does happen.
Today I installed a dado stack for the first time. Total blade width was just under 3/4", so it was kind of a big blade. It was late so I didn't use it very much but this time the shut off rate was closer to 50%. Again I didn't use it much. Actually only 3-4 cuts to get the exact dado width I needed.
Any hints on what's going on.
Today I installed a dado stack for the first time. Total blade width was just under 3/4", so it was kind of a big blade. It was late so I didn't use it very much but this time the shut off rate was closer to 50%. Again I didn't use it much. Actually only 3-4 cuts to get the exact dado width I needed.
Any hints on what's going on.