02-15-2016, 02:22 PM
Hi,
A week or so ago I acquired a FREE Unisaw (yes, you read that right!!)
Anywho, the Unifence that came with is is missing that little plastic indicator thing which I assume has a line in it that should let you set the width of your cut. I'd like to buy one but I want to make sure I get the right one.
My fence can be either "layed down" or "stood upright". Can I assume the little plastic indicator has 2 lines on it, one for fence position #1 and 1 for fence position #2?
(I thought about making 1 out of a piece of plexiglass, but it appears to shaped at a right angle because the screws that hold it to the fence are perpendicular to the table, not parallel.
A week or so ago I acquired a FREE Unisaw (yes, you read that right!!)
Anywho, the Unifence that came with is is missing that little plastic indicator thing which I assume has a line in it that should let you set the width of your cut. I'd like to buy one but I want to make sure I get the right one.
My fence can be either "layed down" or "stood upright". Can I assume the little plastic indicator has 2 lines on it, one for fence position #1 and 1 for fence position #2?
(I thought about making 1 out of a piece of plexiglass, but it appears to shaped at a right angle because the screws that hold it to the fence are perpendicular to the table, not parallel.
Dumber than I appear