Posts: 2,041
Threads: 1
Joined: Feb 2009
Location: Mechanicsville, Md
What I would do is start calling some window replacement companies and have them come out and look at your house. Ask them these questions. Be upfront with them and tell them that you are going to get at least 3 estimates. After 2 or 3 visits, you will have a better understanding of terminology and what is practical and what isn't. Now, keep in mind that at least 1 salesman is going to lie to you and blow smoke up your rear. However, at least you will learn how to spot the dishonest guy and not call him back. I did this when we were doing windows, siding, covering the trim and adding gutters. It was easy to spot the guy that we didn't want touching our house.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.
Garry
Posts: 1,923
Threads: 1
Joined: Aug 2016
I think what you are looking for are called insert windows. Anderson does make these along with other companies. With insert windows you leave the existing frame and interior and exterior trim. Try this
LINK to Anderson as it explains the installation of a insert window. Remember the glass area may be a little smaller with a insert vs full frame. Roly
Posts: 2,115
Threads: 0
Joined: Apr 2005
We did the replacement window thing on our house. Small 1848 farm house, three bedrooms. We wanted to keep the look but reduce the maintenance.
Let me explain. In front we had two 5 x 8 true divided light windows, 40 x 2 + 80 panes to clean. We have lots of big oak trees that snow yellow pollen in the spring which means I have to wash windows in the spring and then again in the fall. (Wife agreement so I can have a wood shop. Win-Win.) So to wash them, I was on a ladder for ever. Then I had to go inside to do those. 80 x 2 = 160. Since the dividers were painted wood, I would have to scrape and paint them, then scrap off any paint on the glass.
So when we decided to replace the windows, we went with interior grids. Looks the same from the outside but I can now clean then with a bucket of warm water, a little bit of Dawn, large scrubber on a stick, and a good squeegee. Now takes minutes and the end result is better. New windows reduced drafts pretty much all over the house. Good long term investment.
For your consideration...
Posts: 63,489
Threads: 3
Joined: Feb 2007
Location: Merryland
Are the existing windows Double Hung windows? Where on or both sashes slide up and down?
If so, you need double hung replacement windows. You remove the old sashes, balances and any track on the sides of the frame. This leaves the exterior framework and interior framework, including the sill in place.
Then you replace those sashes with new replacement windows. Install 1/4 round in the interior around the new frame and caulk everything in place and paint the interior frame and new 1/4 round.
Andersen has a great video n YouTube for installation. Andresen allows you to choose the sill angle when you order replacements. I've never seen that before. Usually you have a sloppy vinyl channel that adjusts to fill the gap left by the angle and you screw and caulk it in place.
Here's the Andersen video:
This is a video installing a vinyl replacement in a more "real world" environment: