08-17-2017, 06:45 PM
I am recycling an old solid core door. Years ago I made a workbench from pallets. I put a 3/4" pressed wood top on it. I am now replacing it with the 1.75" pressed wood door. I am not a big fan of putting the screws into the pressed wood, but I like the idea of screwing up from the bottom, so the workbench top is clean.
Which way would you go. Counter-sink the heads into the pressed wood, and screw into the hardwood, or screw up from the bottom into the pressed wood?
Which way would you go. Counter-sink the heads into the pressed wood, and screw into the hardwood, or screw up from the bottom into the pressed wood?
I tried not believing. That did not work, so now I just believe