Posts: 23,974
Threads: 2
Joined: Sep 2003
Location: Missouri
That's how I did ours. Top and bottom 100lb. 12" ball bearing slides from CSHardware
Your fit needs to be right on, height wise. Get past a 1/16" too tall measurement inside your cabinet, and you'll have trouble putting the slides together.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 18
Threads: 1
Joined: Dec 2016
Thanks. I'll give it a try.
Posts: 5,651
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
so you're talking about cantilevering the load from one side of the drawer? I was just wondering how well that would work. I want to put a narrow drawer next to the stove (under counter vent) and i don't want to build a lot of structure to hold up the second side. I think I have seen 's' brackets to make sure slides are in compression in this application, but I can't find any reference to them
I looked on the accurite web site. No mention of out of plane load, except they say in an undermount application, the load rating is 25%
I was thinking about using an undermount slide upside-down on the top. Or just a regular slide on its side.
Posts: 1,899
Threads: 0
Joined: Jan 2010
I made a rack for two rows of turning chisels that is about 18" wide and 36" high. There are 2 BB full extension drawer slides mounted on the back side, at the top and bottom.
The other half of the slide is mounted to the side of the cabinet located at the end of the lathe. The rack is easily assessable when pulled out and works smoothly.
My .02
Karl
Posts: 5,651
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
the shelves are less than 4" wide, and spices weigh nothing, so there is effectively no out of plane load. And it seems unlikely that anyone would hang on a drawer like that in a way that would pull it away from the slides. I think on my drawer, I'm going to put the top slide on an 'L' bracket so the out of plane load is taken up in the way that the slide was designed.