#21
  
Moving the shop around, I managed to snap off the handle of the fence lock cam on my PM66.  The fence manual I found online says it's part  3076232
I guess I need to find my manual to doublecheck.  It's not too expensive if that's the right number https://www.ereplacementparts.com/lock-c...50846.html

I'm going to try to braze mine first.
Reply

#22
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
Comments down below describes what you did so I would say it's the right part.


Glad its my shop I am responsible for - I only have to make me happy.

Reply
#23
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
Didn't know they had comments there.  "The piece broke in half"  -- yeah, that's what happened to mine, just broke in half Wink
Reply
#24
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
(05-28-2018, 09:27 AM)BloomingtonMike Wrote: Comments down below describes what you did so I would say it's the right part.

I confess, I'm confused, down below what?
Reply
#25
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
way, way down at the bottom of my link, there are a couple of comments.

I'm just not sure if they ever made more than one of these cam locks.  Sure looks like the one in the picture though
Reply
#26
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
Ereplacement parts page he linked has comments.


Glad its my shop I am responsible for - I only have to make me happy.

Reply
#27
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
well, it's not cast iron, more like wax
Reply

#28
  RE: it's always something, broke my PM 66 fence lock cam EricU well, it's not cast ...
(05-29-2018, 01:42 PM)EricU Wrote: well, it's not cast iron, more like wax
............
Die cast most likely...You found out the hard way....Get a magnet. Big Grin
"If you don't read newspapers you're uninformed...If you do read newspapers, you're misinformed.....Mark Twain

Jack Edgar, Sgt. USMC Korean War 51/52
Get off my lawn ! Upset





Reply
#29
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
I decided to fix it by bolting the handle back to the cam via a piece of all thread.  If the fix doesn't work, I'm going to make another one.  The cam is nearly round with an eccentric hole, so I can make it on the lathe.  I need to put the 4 jaw on there anyway, got a project that's too big for the 6 jaw.
Reply
#30
  it's always something, broke my PM 66 fence lock cam EricU Moving the shop arou...
I fixed it, but it doesn't seem the same, so I ordered another one.  They also have the part I need to fix my ROS, so it was nice to combine shipping.
Reply
it's always something, broke my PM 66 fence lock cam


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.