Posts: 7,421
Threads: 1
Joined: Sep 2005
I've built many shelf units from plywood. I just clamp with two bar clamps on each shelf (one on the front and one on the rear). Four shelves will require 8 clamps. Plus one long one if you need to square things up.
No animals were injured or killed in the production of this post.
Posts: 832
Threads: 0
Joined: Apr 2009
Location: Pacifc North Wet --AKA WA
Gent: thanks for the information as I thought the advice given sounded too good to be true! Just need to find and dig out more clamps from the shop storage corner. Again, thanks.
Posts: 4,439
Threads: 0
Joined: Jan 2005
(07-01-2018, 11:55 PM)Ray Newman Wrote: Colleagues: am fabricating a small book shelf -- 72" H x 15" W x 12" Deep from 3/4" plyw'd.
Dadoes will house the shelves and a dado and tongue joint will fit the top and bottom to the sides.
A Fellow Woodworker suggested making 6' long 2x4" cauls to close it all during the glue up. He suggested first rip the 2x4 to uniform width, then place on edge with a playing card (or two) in the center of the cauls and apply pressure to close it all up.
'Nevva' utilized cauls before. My question is: will 6' 2x4 placed on edge bend enough to apply enough pressure to close it all up?
Thanks in advance for any information.
There are several ways to make cauls. 2 x 4 's that are slightly bent to begin with can be used s a caul. Not hard to find, straight lumber, that's hard to find.
If you want to make cauls there are ways to do this depending on your tools and skill.
In your case I would rip a 2 x 6 in half length wise. You will wind up with about 2-5/8" + or -.
Cut to 76" or more. Find center e.g. 38" , divide this in half 19" ,repeat 9-1/2" .Mark these dimensions on each side of center line and connect the dots. If you have a bandsaw or a decent saber saw then use these tools to saw your cauls. You can also hand plane the connecting dots and sand any high spots.
When done, Screw a scrap on each end so the dimension is 1/4" longer than the glue up. This aids in clamping the caul. I generally clamp the middle first. Then each end and remove the middle clamp.
2 x 3 's are better for cauls than 2 x4 's. 2 x 4 's won't bend well because of the width. Soft wood cauls are fine. You can wax the areas that might get glue on them if necessary.
mike
Posts: 10,681
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
If your shelf is only 12" deep, cauls are not required. Just clamp both ends like shown in the Norm picture. If you have k-body or parallel clamps, they'll work even better.
Still Learning,
Allan Hill