07-18-2018, 04:19 PM
So, this week I am off and I have been working on several tools that I have purchased in the not-so-distant past and now and finally getting the time to getting them ready to use. I changed the knives on my jointer and it is now functioning correctly. Very happy about that, and then on to the bandsaw. I changed the tires the bearings adjusted the blocks and change the blade I can now we saw it about 1/16 of an inch. Without upgrading to roller guides is this good? Would roller guides in prove it? This is an open stand Delta 14 in from the mid-nineties I believe. Also I'm including a picture of the packing so you can see the blade I am using. If you can't see the picture it's a 1/4 x 6 TPI.
"Life is too short for bad tools.".-- Pedder 7/22/11