I am probably going to be moving within the next 6 months, I currently have an open stand General jointer with 54 in infeed/outfeed...its a 6 inch jointer. Going to probably go down to something like at 12x16 or maybe a 12x20. I was considering selling my current jointer since it would be such a spacehog in a very small shop. If you use a benchtop jointer I'm curious what you're thoughts are on not only the unit you have but my plan as well. Probably gonna sell my Delta contractor's saw and go back to a jobsite saw as well. Keeping the Delta 14 inch BS and floor DP.
Thoughts?
Thanks
Thoughts?
Thanks
"Life is too short for bad tools.".-- Pedder 7/22/11