05-03-2019, 02:36 PM
Wondering if any Woodnetters have used a tool cabinet as a table base? The 41" length is perfect for the Incra router fence that's been on the shelf here for 2 or so years waiting to be used.
[attachment=18231]
I'd take the top 3 drawers out of the right side, seal the inside with plywood and add a door. The top would be covered with 3/4" BB plywood to support the particle board door top. There will be some overhang on the sides which will limit the access to the back of the top drawers. Not a big deal.
Anyone here done something like this? I'd love to see pics before cutting into the top of a new cabinet.
Thanks for reading, g
[attachment=18231]
I'd take the top 3 drawers out of the right side, seal the inside with plywood and add a door. The top would be covered with 3/4" BB plywood to support the particle board door top. There will be some overhang on the sides which will limit the access to the back of the top drawers. Not a big deal.
Anyone here done something like this? I'd love to see pics before cutting into the top of a new cabinet.
Thanks for reading, g
I've only had one...in dog beers.
"You can see the stars and still not see the light"
The Eagles: Already Gone
"You can see the stars and still not see the light"
The Eagles: Already Gone