Judy volunteered me to build some frames and I agreed.
Made the first and took it over for a test fit.
The puzzle manufacturer stated it’s 20” X 20”— my corners at the inside of the rebate are 19-15/16” X 20”
The puzzle is more than 1/4” wide on the 20” side; the other side is just a hair small.
The frame has lots of molding.
What’s the best way to widen the rebate?
I think trying a TS stop cut is too unwieldy.
I’m thinking I should take a router to it with an uncut spiral bit?
Any better method?
Made the first and took it over for a test fit.
The puzzle manufacturer stated it’s 20” X 20”— my corners at the inside of the rebate are 19-15/16” X 20”
The puzzle is more than 1/4” wide on the 20” side; the other side is just a hair small.
The frame has lots of molding.
What’s the best way to widen the rebate?
I think trying a TS stop cut is too unwieldy.
I’m thinking I should take a router to it with an uncut spiral bit?
Any better method?
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.