#5
  
I just became the owner of an Artsign JSM-40U laser engraver... It is a used machine in good condition, but the software for the computer didn't come along. Can anyone help me find software for this machine? I have looked without any success...
Reply

#6
  Software need for laser engraver teaberry I just became the ow...
Those Chinese machines can/are troublesome.  I don't know if it runs RD Works or not.  Go here, join and ask your question, as you're gonna have lots of them trying to get it to run.  Very helpful people.
https://rdworkslab.com

RP
Reply
#7
  Software need for laser engraver teaberry I just became the ow...
That is basically the generic K40 laser.

I would try here: http://www.scorchworks.com/K40whisperer/...perer.html   This is free software, but is better than what originally comes with the machine (a modified stolen Corel package)

If that doesn't work for you, and you are thinking about upgrading at all, try here: https://lightburnsoftware.com/  but you may need to upgrade your control board.  I am using a Cohesion3D setup in a similar laser and the improvement is massive.  https://cohesion3d.com/shop/controllers/...aserboard/
Reply
Software need for laser engraver


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.