#10
  
I normally hang around in the Hand Tool group - I do a bit of turning, mostly to make replacement handles for yard sale chisels and the such.

A few years ago, I bought a bunch ( 30 or so ) bolstered scratch awl metal ' bits ' from Lee Valley - should have bought 100 - I turn handles and give them away - and am nearing the end of my supply. They are a total length of about 4 inches, and the shank part of the awl is just over 1/8''.

I have O-1 stock that I could easily make them, but it is the bolster that I like.

Any ideas as to a supplier out there for such a thing?

Regards;

Dave Beauchesne
Reply

#11
  Bolstered scratch awl - where to purchase? DaveBeauchesne [size=small][font=Ve...
Just so everyone knows, What Dave is looking for 
(I believe this is Dave's picture from LJ )

Dave wants the metal point with the STOP disk on the shaft. it stops the rod from going deeper into the wood handle

[attachment=23615]
Life is what you make of it, change your thinking, change your life!
Don's woodshop
Reply
#12
  Bolstered scratch awl - where to purchase? DaveBeauchesne [size=small][font=Ve...
Dave

Nice to see you here and I missed your post at LJs.  I either use a copper or brass piece I get from a pipe and for small awls I use 3/8 fitting.

If you do not want to get a length of pipe from the box stores then you can order pieces from EBay at a size you wish.

I just used the last of my copper 5/8" and 3/4" but if you send me the awl I will make one for you since you are my buddy.

Send me a PM if you want me to and type of wood and if I do not have it you can send me a piece of the wood to.
It is always the right time, to do the right thing.

Hi, I'm Arlin's proud wife! His brain trma & meds-give memory probs and has pain from injuries, but all is well materially & financially.  
Reply
#13
  Bolstered scratch awl - where to purchase? DaveBeauchesne [size=small][font=Ve...
Have you contacted Rob Lee to see if maybe they have some NOS that was pulled and shelved, or who their supplier was?
Steve

Missouri






 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply

#14
  RE: Bolstered scratch awl - where to purchase? Stwood_ Have you contacted R...
(01-30-2020, 07:37 PM)Stwood_ Wrote: Have you contacted Rob Lee to see if maybe they have some NOS that was pulled and shelved, or who their supplier was?

I use music wire 5/32. Check out this video I did and check out the Affiliate links  below the desctiption for a source. https://www.youtube.com/watch?v=0Sc7l7Uz6vY&t=185s
Mike

"Start off slow and taper off."
Reply
Bolstered scratch awl - where to purchase?


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.