#16
It has a very flat head, like a pan head but the top is flat, and very thin. Probably metric because the parts lists calls it a m27-1.5 inches long. The point if flat.

The screw is to hold a slider metal bar on a porch swing into an upright made out of Trex.

Any name so I can source some?

4 or 5 mm hex drive, not that it matters.
Reply

#17
Not sure about the name but I would look up deck screws
Phydeaux said "Loving your enemy and doing good for those that hurt you does not preclude killing them if they make that necessary."


Phil Thien

women have trouble understanding Trump's MAGA theme because they had so little involvement in making America great the first time around.

Reply
#18
The head type could be listed as truss or wafer. Socket drive.
Reply
#19
Cap-Tor   (maybe)
"the most important safety feature on any tool is the one between your ears." - Ken Vick

A wish for you all:  May you keep buying green bananas.
Reply
#20
Looks like a pocket hole screw to my non-expert eye. Check McFeeley's
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#21
Not sure about your screw but how about this? https://www.mcmaster.com/screws/tapping-...r-plastic/
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Reply
#22
(09-11-2020, 08:39 PM)sroxberg Wrote: It has a very flat head, like a pan head but the top is flat, and very thin. Probably metric because the parts lists calls it a m27-1.5 inches long. The point if flat.

The screw is to hold a slider metal bar on a porch swing into an upright made out of Trex.
https://shopee.com.my/M5-M6-Button-Head-...1695973761

4 or 5 mm hex drive, not that it matters.

Might be a button head screw. Closest I've come is here: https://shopee.com.my/M5-M6-Button-Head-...1695973761
Reply
#23
The threads look very similar to those used for particle board or MDF. Closest I can come up with a a truss head deck screw.
Still Learning,

Allan Hill
Reply

#24
(09-13-2020, 06:09 PM)AHill Wrote: The threads look very similar to those used for particle board or MDF.  Closest I can come up with a a truss head deck screw.

That’s my impression.  A thick wafer head screw, for particle board.
Tom

“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Reply
#25
(09-11-2020, 08:39 PM)sroxberg Wrote: It has a very flat head, like a pan head but the top is flat, and very thin. Probably metric because the parts lists calls it a m27-1.5 inches long. The point if flat.

The screw is to hold a slider metal bar on a porch swing into an upright made out of Trex.

Any name so I can source some?

4 or 5 mm hex drive, not that it matters.

https://www.homedepot.com/p/Everbilt-7-m.../204273733

Wafer head socket cap screws, usually called connecting screws. Common in flat pack furniture and outdoor DIY playgrounds.
Reply
What type of screw is this?


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.