Yorkcraft YC-8J again. I did something or other stupid a long time ago, and bent this pin. It catches the depth gauge (a sheet metal part not shown in the pic). It's not essential, but before I cut if off and grind it flat, is there any hope of replacing it? I assume it is press fit, so I am not seeing how.
Thanks.
Thanks.
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web: My woodworking photo site
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web: My woodworking photo site