02-26-2021, 12:58 AM
I am starting a dinning room table out of QSWO. The 4 legs are 5" square x 28" long out of 3/4" jointed with the Whiteside lock miter bit. I want all 4 sides to be quarter sawn. It has been around 10 years since I used the lock miter bit, I know how to set up the bit, at least I used to. I have not used the bit on oak before.
So my question is should I make the full cut on each board or, as I am looking at the bit, can I add a temporary 1/4" fence and make the first cut then remove the temp fence and finish with a second cut? will that work? Any helpful suggestions?
So my question is should I make the full cut on each board or, as I am looking at the bit, can I add a temporary 1/4" fence and make the first cut then remove the temp fence and finish with a second cut? will that work? Any helpful suggestions?
Treat others as you want to be treated.
“You only live once, but if you do it right, once is enough.” — Mae West.
24- year cancer survivor
“You only live once, but if you do it right, once is enough.” — Mae West.
24- year cancer survivor