03-04-2021, 02:42 PM
It's a 24"x96" roll of veneer from Rockler. I've never worked with it before, so how best do I uncoil a new roll of sticky back PS veneer?
I suppose I should cut the lengths I'll use and then flatten them from there, rather than try to flatten the whole roll as one piece.
How best to get this stuff flat? Wet it with water or ms with weights on the ends?
thanks for your experienced suggestions
Ray
I suppose I should cut the lengths I'll use and then flatten them from there, rather than try to flatten the whole roll as one piece.
How best to get this stuff flat? Wet it with water or ms with weights on the ends?
thanks for your experienced suggestions
Ray
Ray