04-25-2021, 10:51 AM
I'm thinking about making a bar stool using larger diameter dowels (let's say 1 1/4") for the legs, but I want the stretchers to match the profile of the dowel where they meet.
I don't have a drill press, though, and I didn't think it was a good idea to cut into the dowel to make a flat area.
Any recommendations on how I can do this?
Thanks
Paul
I don't have a drill press, though, and I didn't think it was a good idea to cut into the dowel to make a flat area.
Any recommendations on how I can do this?
Thanks
Paul