#10
Recently picked up a veritas shooting board plane off Craigslist. It was unopened so I’m assuming this is how it came from LV. I notice the backing board does thot sit flush with the base. About 1/8” higher.  If I flip it end over end the. It does sit flush but having it in that configuration i can’t shoot boards at 45 degrees because the backing board sticks out too much. Not a huge problem obviously since it’s easy enough to make another backing board but was just curious if this is how it normally comes from LV. And if so, why?
Reply

#11
Something is mounted wrong or drilled wrong. In addition to the gap, the fence should be flush with each side of the base.
Reply
#12
I can move it laterally and have it flush to sides now but I can’t move it down to make it flush with bottom. I’ll double check when I get home today if something is mounted wrong but I didn’t see anything originally.
Reply
#13
Not a major deal to make your own board if need be
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#14
I have always been under the impression that Lee Valley sells the shooting board and fence without the sacrificial extension.

The extension is user made.

Simon
Reply
#15
Hi- 

As Simon notes, that fence is user made....not supplied with the shooting board..

Cheers, 

Rob
Reply
Veritas shooting board - backing board problem


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.