I was kind of all set to pull the trigger on the onefinity when I found a really good deal on a nearly new shark HD510. I know the seller well and am confident it is in like new condition. The shark will end up being around $600 more when factoring in shipping for the onefinity. I will also have to make a base/spoil board for the onefinity. The shark already has one. Neither include a router but the shark can use a variety including midsized routers while the onefinity can only be used with the makita trim router. But in the future I plan on upgrading to a water cooled spindle so I'm not sure it matters. Any advice from experienced users?
https://www.onefinitycnc.com/product-pag...odworker-1
https://www.rockler.com/next-wave-shark-hd510
https://www.onefinitycnc.com/product-pag...odworker-1
https://www.rockler.com/next-wave-shark-hd510