#13
Because this is a Hand Tool thread....
[attachment=45732]
And the doors of this Tool Chest are more of a Ready Service Rack for the hand saws in the shop....ones that will get used the most...

Time to open the doors for a look around?
[attachment=45733]
What you'll see when the Left side is opened...and..
[attachment=45734]
What you will see when the Right side is opened.....there is also a Til for a few hand planes, nearby..
[attachment=45735]
 More for the larger Jointer planes, and a few Jacks....and some "extras" 

So...anyone want to see the close-ups  in the Tool Chest?  
Winkgrin
Show me a picture, I'll build a project from that
Reply

#14
Sweet!
Close-up vote, YES (1)
If you continue to cut corners, you'll end up going in circles!

It's my thumb so I'll hit it if I want to!
Reply
#15
Wowser 
Cool

seventeen
Greg

It's better to burn out than it is to rust

Danchris Nursery
Reply
#16
Left side door...has a couple block planes..
[attachment=45750]
Had to cut that rack down to fit IN the door...next, glance up towards the top of the left door
[attachment=45751]
Mainly Joinery saws...next, turn to the right a bit..
[attachment=45752]
A rack for the Try squares...a Stanley No. 80 scraper...14" sweep Stanley, 12" and 10" Pexto Samson braces..and another fancy saw..next..
[attachment=45753]
Starting to get into the supply of hand planes...Middle section has mostly planes and drills..
[attachment=45754]
There is a Stanley #6c in there...a couple #5-1/2 planes...a few #3 and #4 sizes...and a WR #62..drills?
[attachment=45755]There are a pair of 6" sweep braces...and a Goodell Pratt 10" brace....and a few eggbeaters...there is a #60-1/2 Low angle plane sitting on the shelf, too..

over into the right hand corner...
[attachment=45756]
Bevel gauges, rack of combo squares...pair of hacksaws..Stanley SW Marking gauge...
[attachment=45757]
3 more marking gauges.  4pc Expansive bit set...
[attachment=45758]
Which leaves the right hand door....
[attachment=45759]
Sitting in a bag behind the level, is a 90 degree drill chuck...last used to build Aircraft in WW2....

And that should do it for this tour...?
Show me a picture, I'll build a project from that
Reply
#17
Thanks for the tour Bandit. When does the room addition start? Only a couple of months 'til the picking season opens.
If you continue to cut corners, you'll end up going in circles!

It's my thumb so I'll hit it if I want to!
Reply
#18
Wow, that is packed.  Are you going to start on a second one?
Reply
Tool Chest Tour, 2023 version


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.