#11
Looking for a good source for a Chisel mallet for dovetails

Thanks
Reply

#12
Have you considered making your own?
Reply
#13
Don't have a lathe
Reply

#14
(11-26-2024, 06:20 PM)davco Wrote: Don't have a lathe

Make a flat faced one.  

John
Reply
#15
I have made several; all are similar, in shape, to the "Big Horn Wood Mallet".  Answering your question...Google.  But I would hate to be limited to one mallet.  To my surprise, I use my small mallet probably 90% of the time.  I just completed eight drawers and used only the small mallet.  Just a guess, mallet weighs 10 ounces.

I have used a "flat head" mallet one time and did not like it.

Good luck.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply

#16
(11-27-2024, 09:01 AM)Bill Holt Wrote: I have made several; all are similar, in shape, to the "Big Horn Wood Mallet".  Answering your question...Google.  But I would hate to be limited to one mallet.  To my surprise, I use my small mallet probably 90% of the time.  I just completed eight drawers and used only the small mallet.  Just a guess, mallet weighs 10 ounces.

I have used a "flat head" mallet one time and did not like it.

Good luck.

I have one of these I picked up and is stamped "Highland Hardware" before the name changed. Have never had or used one of those barrel shaped mallets, but I like this one.

Doug
Reply
#17
(11-27-2024, 09:01 AM)Bill Holt Wrote: I have made several; all are similar, in shape, to the "Big Horn Wood Mallet".  Answering your question...Google.  But I would hate to be limited to one mallet.  To my surprise, I use my small mallet probably 90% of the time.  I just completed eight drawers and used only the small mallet.  Just a guess, mallet weighs 10 ounces.

I have used a "flat head" mallet one time and did not like it.

Good luck.

Bill has a very good point.  Big mallets have their place like timber framing, but not when it comes to fine work.
For years I used a hardwood handrail cut-off for precise work with a chisel because it was far more predictable than my heavier mallets.  Eventually I turned a much smaller and lighter mallet and now use that.
Below is the best photo I've got of that handrail cut-off.  I think the widest part is less than 2" wide.
Try several weights of scrap stock and see what weight works best.  I know one woodworker that had been doing dovetails for decades with the flat of a 16 oz. hammer held in his palm.


[attachment=53118]
Reply
#18
I made my round mallet with a block plane and spoke shave. Its not lathe quality but it whacks chisels pretty well.
Reply
#19
If you're dead set on a round mallet, how about this one? It's a little on the small side but I like it for precision chisel work. I don't have a lathe either but have made many laminated square head mallets and am also really happy with these also.

[attachment=53120]
Reply
Chisel mallet


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.