Woodnet Forums › › Active › Woodworking v
slab table help needed
Thread Modes
slab table help needed
pinky Offline
Member
Posts: 2,063
Threads: 1
Joined: Feb 2005
Location: Marco Island, Fl.
#13
10-29-2016, 02:05 PM (This post was last modified: 10-29-2016, 02:06 PM by pinky.)
Do you see any issue with a 13' 6" top? I have them about 10' apart measured from the farthest point on the bases. With overhang it's getting up there. I can't see pushing these closer than I have them in the picture.

[Image: IMG_0886_zpsneat9pbr.jpg]
Find
Reply
Bill Holt Offline
Member
Posts: 2,384
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
#14
10-30-2016, 04:47 PM
Personally, I would have them a little closer to have  24" to 28" overhang on each end.  I would probably cut a 2x4 to 13' 6", place it on top then step back and decide.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.