Woodnet Forums › › Active › Woodworking v
Plexiglass
Thread Modes
Plexiglass
The Tinman Offline
Member
Posts: 545
Threads: 0
Joined: Jul 2007
Location: Harper, Kansas
#15
10-07-2017, 12:22 PM
We cut a whole lot of lexan at work which is also a polycarbonate, and we just use a standard ATB combo blade. Also another thing that hasn't been addressed yet, if you have a sawstop make sure to turn the sensor off. First hand experience-- it will set it off.
It's not always the quiet ones who don't have much to say.
Find
Reply
Dusty Workshop Offline
Member
Posts: 4,787
Threads: 0
Joined: Jan 2005
#16
10-08-2017, 06:13 PM
Here's is a link to the Plaskolite website.

Lot's of good info on acrylic fabrication.

http://www.plaskolite.com/Fabrication/Ac...-Machining
The ALS Association
Lewy Body Dementia Association
Find
Reply
DogwoodTales Offline
Member
Posts: 1,028
Threads: 0
Joined: Apr 2011
#17
10-13-2017, 08:53 PM
When cutting plexiglass or lexan on the ts I run a shallow scoring cut first then a through cut just like I do on veneered plywood for a clean cut on both sides with no chip out.
Ray
Website Find
Reply
daddo Away
Sparky
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
#18
10-13-2017, 09:03 PM
A small toothed metal cutting blade on the bandsaw does an excellent job as well. I use a slower feed and speed.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.