Woodnet Forums › › Active › Woodworking Power Tools v
Adding an extra top to my table saw
Thread Modes
Adding an extra top to my table saw
ez-duzit Offline
Member
Posts: 589
Threads: 0
Joined: Jan 2017
Location: Marina del Rey
#13
08-26-2019, 10:15 AM
On one side of my shop I have a Unisaw, with carbide rip blade, and a contractors saw, with carbide dado stack, married together on a mobile base. These 2 saws share a Beismeyer fence. On the other side I have a Unisaw, with carbide combination blade, and a re-purposed cast iron table saw top, with a 3-1/2 hp router beneath. These 2 machines share a Unifence.

[Image: shop-2.jpg]
[Image: shop-1.jpg]
Wood is good. 
Find
Reply
Big Dave Offline
Honored Veteran
Posts: 6,755
Threads: 0
Joined: Aug 2001
Location: Post Falls, ID
#14
08-30-2019, 11:34 PM
My two saws work pretty well together. No reason to think yours won't as long as they're properly supported...

[Image: LHL2M4I.jpg]
"One should respect public opinion insofar as is necessary to avoid starvation and keep out of prison, but anything that goes beyond this is voluntary submission to an unnecessary tyrany, and is likely to interfere with happiness in all kinds of ways."
Website Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.