You remind me of the Old tool users back 1950's and earlier who mostly only had hand tools and doing what they had to, to get the furniture they needed.
Now all you have to do is cut a tree down and mill it all up by hand and them make the furniture. Please make sure you take pictures of that to.
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
The Ash came from a friend's woods....he has another friend with a bandsaw mill...they go "Halfs" when a tree gets dropped. That is where I go for most of the hardwood I use.
Project came from a 12' 1 x 6 skipped planed Ash board....and 10' of a 2 x 4 of Ash....both from the same tree. Other than the plywood for the shelf, and a couple Walnut plugs, everything was made from just those two pieces of Ash.
(12-04-2018, 11:44 AM)bandit571 Wrote: Next project may be a good clean up of the shop....getting a bit cluttered...need places to store a few tools....
Build a cabinet over the top of that washer and dryer.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Going to rebuild the end vise on the bench...first.....3+ years of staedy, hard work....has taken it's toll....Will stop by Menard's cut-off bin...try for a few short pieces of 2 x 8...or just rip a 2 x 12 down...
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
Please make sure you take pictures of that to. 
